国外木质结构DIY巨型4米8000升水族箱再次福利贴！学习~

后面没有了吗

工程不小啊

强大

继更新
Next we finished building the walls, in this section you can see the wholes left for the windows with the top of the frame on them now.
接下来我们完成了墙壁，在这一环节中你可以看到整体框架上顶部的窗口。

Next we layed 1/2" thick plywood down over the floor of the pond, and did the same for the walls. I don't have any pictures from right after adding it to the walls but you can see it done in Part 7.接下来用厚的胶合板作为池塘的地板，

接下来我们用玻璃纤维马特所有角落聚酯玻璃钢树脂。这是在4个角落做何墙壁与地板，需要强大的，我们是最有可能泄漏的地方。我们认为在这整个池塘涂层Matt但决定我们宁愿自杀了。马特我们在使用很松散的和困难的工作，并吸收了色调的树脂，如果我们有更好的玻璃纤维马特可能也没有那么糟糕。

在与玻璃纤维也经历了邦坦克和填充任何孔或大的裂缝，树脂不填写的开始，给我们一个很好的表面光滑。

对聚酯树脂的注意，我们用来做最初的几层因其便宜（每加仑40美元）与环氧树脂（每加仑90美元，在本地不可用）。聚酯树脂不应作为最后一层是不是鱼安全。稍后您将看到我们是密封在环氧树脂涂料。

After the fiberglassing in the corners had dried we went ahead and layed down a coat of polyester resin over the entire pond, this was done using paint rollers. Other than the fact that the stuff smells horrible it was pretty easy to put on. We did 5 coats of polyester resin using about 12 gallons of resin, each one waiting about 24 hours for it to dry.

晒干了我们先倒一层聚酯树脂在整个池塘，这是使用涂料辊。

了解了

欣赏了